Proto
Protyping accessories
26 pin Cobbler (Cobbler26)
26pin ribbon cable included..
Breadboard sold separately.
Breadboard sold separately.
GPIO bus to Breadboard adapter
9V Power Cable Bare (9Vclip)
9V Battery Power Cable
with Bare Leads
with Bare Leads
9V Power Cable with Bare Leads
Out of Stock
CAD$0.45
9V Cable with Jack (9Vbarrel)
9V Battery Power Cable
with Barrel Jack for Arduino Uno
with Barrel Jack for Arduino Uno
9V Power Cable for Arduino Uno
USB Cables (USBcable)
various cables...
"micro" is typically used for the Nano32 - 1m long
"mini" is typical for the "normal" Nano - 1m long
the "A" extension is good for the USBasp - 1m long
NOTE - the micro with switch is POWER-ONLY - no data - NOT for Uploading.. 2m long
- Colours may vary from photo.
"micro" is typically used for the Nano32 - 1m long
"mini" is typical for the "normal" Nano - 1m long
the "A" extension is good for the USBasp - 1m long
NOTE - the micro with switch is POWER-ONLY - no data - NOT for Uploading.. 2m long
- Colours may vary from photo.
Various USB Cables
USB BreakOut (USB_BO)
pins included for breadboard use...
ideal for adding OTG USB to the Saola
Nano uses miniUSB
Nano32 and ESP-XX use microUSB
BreakOut board for USB / OTG
USB to UART (USBUART)
- Connect to your Pi or Arduino Serial Port via USB
- Connect the 3 female jumper connectors to your development board's RX, TX and GND pins
- Then use Putty to communicate with the corresponding COM port such as /dev/ttyUSB0
- The Prolific is NOT Recommended for Windows 8 or 10
USB to UART Converter 3.3V
- 1