Kit Offers

CH32V573 with BlueTooth

<<< Code Sample >>>

available at: the github.

Our own CanHobby design using the CH32V003 RISC-V microcontroller.

The USB port is not designed for uploading..  It is possible with some versions of Windows BUT not Linux. It can be programmed as a serial port.

The use of a LinkE is recommended.

See Related Products to complete the kit.

Our own CanHobby design using the CH32V003 RISC-V microcontroller.

The Link-E is required to upload firmware.

The internal 8MHz Oscillator works great - crystal is not necessary.

The "Crystal" solder pads may be used as additional GPIOs if the crystal is not installed. (PA1, PA2).

see Related Products to complete a Kit with Link-E and/or 8, 12, 24, 32MHz Crystal.

A +5V / 3V3 jumper selection is provided to enable compatibility with 3V3 or +5V peripherals connected to the GPIOs.

WCH CH32V003 EVAL Board for use with EVAL code samples.

<<< Hackaday Project  >>>

CH582M with BLE

We-Act Studios dev Kit

<<< Sample Code >>>

Hackaday Projects

CH582M with BLE

<<< Sample Code >>>

3 NEO Pixels

ESP32-C3FH4 WeAct

160 MHz single RISC-V core

4Meg Flash + 400K SRAM

13 GPIO + Tx and Rx pins

Upload  is via the Built-In USB I/F

USB-C connector for code upload and Power.

WiFi and BlueTooth on-board Antenna

Excellent Arduino IDE Support.

<<< Sample Code >>>

BLE with App

CH32VC8T6 EVT Dev Board

Full Up development board - original WCH Design

<<< Sample Code >>>

Using CH32Vxxx Risc-V and Moun River - Hackaday

CH32V203 freeRTOS on MRS II - Hackaday